update 3/20/2023 - added an update/change log section below This design did present some challenges that needed to be accounted for, and from examples Ive seen, some pitfalls to at least explain. 1. Yes there are screws, and yes they are not counter sunk. The original screw version uses 14x M3 4mm machine screws. You have to sandwich the elastic in between the two plates somehow. It is doubled in places - and with sewing that can create some thickness - you want some strength to hold it all together. Pan head screws keep the screw holes small, and the area around the screw holes remains thick. The pan head screws also give it a unique design element of my own. 1. At least 400mm of 1inch or 25mm Elastic band - i used [this](- which is also available at many stores in the Us. I was able to find both Black and White to open up more color variations. 2. 14 M3 4mm pan head machine screws (7 for each side) 3. Strong Ca glue if you decide to use the no-screw version. 4. Needle and Thread to sew the elastic 4. For the screw version - you may want to clear the screw holes with a 2.5mm bit for the bases and a 3mm bit for the covers - then attach the covers over the elastic onto the bases with the 14 M3 4mm screws. 5. For the no screw version - Use good strong Ca glue or epoxy - then assemble the Base and Cover for one side and clamp it when its aligned. Here is where your sew-job is measured, as the cover will bow a little then settle under clamped pressure as the elastic seats. Once one side is cured, do the other. This eliminates having multiple pieces slipping around. 6 Lastly, slip the money clip over the band using the slots in the center of each end. See the photos for reference. If i missed anything - hit me up int he comments - Good luck! Источник: https://www.thingiverse.com/thing:5867497 Автор: revere521 Лицензия: Creative Commons - Attribution - Non-Commercial - Share Alike